I know auto merge is going to rear it’s chucklike head but here we go.
I could use a little advice on this f***ing turtle tank.
The black uprights are pvc, easily cut when outside the tank. Inside, the vibrations might break the tank.
The tank is glass, not tempered glass.
The secondary swimming area is also glass, not tempered glass.
The bulkhead of the secondary swimming area is crenellated and actually two separate pieces of glass as I could not notch squares out with a glass cutter. The sections are bonded together with gorilla super glue gel.
The bulkhead is also bonded to the base of the secondary swimming area with super glue gel.
All of it has a bead of silicone ran around it to make it water tight.
The problem is I adjusted my plan at the last minute to factor in the turtles growth and raised the platform. Now the turtle will be unable to climb up a ramp and get into the area as it’s at the top of the tank.
I do not know if I can separate the bulkhead from the base and if I am unable to, I am unable to angle the base to get it out of the tank.
What in the f*** can I do?
View attachment 662587